Quanzhou Juhui Electronics Co.,Ltd.
Categories
Related Products
Garage Door Remote Replacement
Sliding gate opener receiver
Remote Control Duplicator JH-TX278
Infrared Beam Sensor for Roller Shutter Garage Door - Photocell - NC or NO
4 channel 220V AC/DC motor receiver
4 channel 220V AC/DC motor receiver
Description
Instruction Manual:
The radio control units included in the pack are already programmed and ready to use. Zones1 and 2 can operate independently in bistable or timed mode.
Setting the mode of operation:
ZONE1
BISTABLE: Remove the jumper on terminals1and 2
TIMED: Insert the jumper on terminals1and 2
ZONE2
BISTABLE: Remove the jumper on terminals 2and 3
TIMED: Insert the jumper on terminals 2 and 3
Radio control acquisition:
ZONE1
1. Press keyP1 on the control unit once to program exitZ1; The LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED on the main control unit starts to flash; Release the key.
ZONE2
1. Press key P1 on the control unit twice to program exitZ2; The LED will remain on.
2. Press and hold the key to be acquired on the radio control unit until the LED starts to flash; Release the key.
Setting the work time: (time the exitison)
Only if TIMED MODE is used
ZONE1
Press key P2 on the main control unit once to set the work time for exitZ1, the LED will set on exitZ1, after which press key P2 again. The LED will flash three times to confirm.
ZONE2
Press key P2 on the main control unit once to set the work time for exitZ2, the LED will come on.
Wait a length of time equal to the WORK TIME to be set on exitZ2, after which press key P2 again. The LED will flash three times to confirm.
Deleting the radio control codes:
Deleting an individual code:
Press and hold keyP1 on the main control unit for 5 seconds (release the key); The LED will remain on. Press the key on the radio control unit to be cancelled until the LED begins to flash.
Deleting all codes:
Press and hold keyP1 on the main control unit for approx. 10 seconds, the LED will come on, then release the key. The LED will emit 3 flashes to confirm the deletion of all the codes.
The Exhibition Show
Certification
Delivery
MESSAGE
CONTACT US
ADD:No.288 changxing Road,Huoju Industrial District,Licheng Area, Quanzhou,Fujian,China.
E-mail:qzjuhui@163.com
Tel:86-59522622065
