Quanzhou Juhui Electronics Co., Ltd!
Product classification
Reflective infrared photoelectric tube
Product number:
Classification:
Key words:
Product Introduction
Reflective infrared photoelectric tube
Used to detect obstacles in the installation of automatic doors and gates, preventing collisions with the door/gate. They consist of an infrared transmitter module (TX) and a receiver module (RX). If a person or object obstructs the beam emitted by the transmitter (TX) (or if the beam fails to reach the receiver due to a setup failure or loss), the receiver (RX) will activate the corresponding relay and notify the installation control unit.
| Brand: | Juhui or custom |
| Model: | JH-IR09 |
| Model | Active infrared beam sensor |
| How to use | Refer to the manual |
| Receiving distance | 15-20 meters |
| Usage | Garage door/gate/sliding door. |
| Frequency | 433.92MHz |
| Power supply | Receiving end: 3V Transmitting end: 12 - 24V DC, AC |
| Power consumption | Transmitting end: 0.1mA Receiving end: 17mA |
| Rotation angle | 180 |
Product application:Lifting doors, revolving doors, sliding doors, wall safety protection, window balcony safety, warehouse safety, parking lots, and other outdoor safety locations.
Product installation and precautions:
1) Please operate within the maximum detection range.
2) Install the reflector in a suitable position, facing the sensor.
3) Adjust the sensor position according to the reflector, aligning the sensor with the center of the reflector. [During initial installation and debugging, first secure the sensor, align the reflector with the sensor, and then move the reflector from near to far to the desired position.]
4) Do not power the sensor until all electrical connections are completed.
5) During debugging and installation, avoid the product's blind spots [unable to sense obstacles in blind spots].
Installation:
(1) Install the receiver (RX), avoiding direct sunlight (infrared radiation).
(2) Choose the positions for the transmitter and receiver devices. These two modules should be aligned as closely as possible.
(3) The installation height of the photoelectric tube depends on the installation situation (generally recommended to be installed below 300mm from the ground and below 200mm from the door leaf).
(4) Connect the power supply. When the receiver correctly receives the beam emitted by the transmitter, the normally closed contact remains closed, and the LED light is off. When the beam is interrupted, the normally closed contact opens, and the LED light turns on.
Application:
Mainly used in barriers, motorcycle anti-theft devices, car anti-theft devices, home security systems, emergency buttons, garage doors, rolling shutters, etc.
Car space
Previous:
The next one:
Online Consultation
* Note: Please be sure to fill in the information accurately and keep the communication unblocked. We will get in touch with you as soon as possible.
Message
Contact Us
Address: 288 Changxing Road, Quanzhou City, Fujian Province
E-mail: alee@juhuico.com
Phone: 86-59522622065